Hello, I am using a treadmill motor and motor control board to power a potters wheel and have blown the tread mill display board.
The motor control board connects to the display board through pins labelled l w h h m +12v and gnd
I have read online that l w and h are for the pot low wiper and high
that doesnt start the motor though.
Is there any way to use this plug to control the motor?
Heres a photo of the control board :
http://s567.photobuc...gcayyf.jpg.html
And a close up of the connections ive got
http://s567.photobuc...vyc0hf.jpg.html
The Motor is 180v 4 amp permanent magnet if that helps