Jump to content


jamesl2322

Member Since 18 Jul 2015
Offline Last Active Jul 20 2015 09:19 AM
-----

Topics I've Started

Dv Motor Control

18 July 2015 - 06:15 AM

Hello, I am using a treadmill motor and motor control board to power a potters wheel and have blown the tread mill display board.
 
The motor control board connects to the display board through pins labelled l w h h m +12v and gnd

I have read online that l w and h are for the pot low wiper and high

that doesnt start the motor though.

Is there any way to use this plug to control the motor?

 

Heres a photo of the control board :

http://s567.photobuc...gcayyf.jpg.html

And a close up of the connections ive got

http://s567.photobuc...vyc0hf.jpg.html

 

The Motor is 180v 4 amp permanent magnet if that helps

 

Note : ive replaced c10 as it had blown, i cant see any other faults with the control board it lights up fine, I am just not sure how to wire it up to make it rum without the display board,

 

Any help would be greatly appreciated,

 

Cheers, James


Help : Motor Control Board

18 July 2015 - 06:00 AM

Hello, I am using a treadmill motor and motor control board to power a potters wheel and have blown the tread mill display board.
 
The motor control board connects to the display board through pins labelled l w h h m +12v and gnd

I have read online that l w and h are for the pot low wiper and high

that doesnt start the motor though.

Is there any way to use this plug to control the motor?

 

Heres a photo of the control board :

http://s567.photobuc...gcayyf.jpg.html

And a close up of the connections ive got

http://s567.photobuc...vyc0hf.jpg.html

 

The Motor is 180v 4 amp permanent magnet if that helps