Jump to content

Broken Bars In The Rotor Of Induction

osama ali

Recommended Posts

Dear sir

many times vibration and motor current signture analysis survey performed for the motors at our site and the report clear the motor has broken and /or cracks in the rotor but after dismantle the motor and pullout the rotor found the rotor doesn't suffering from any kind of broken bar or cracks at ambient temp.

your kind support to advise me how can detect these cracks and beoken bars at workshop?


Link to comment
Share on other sites

Hello osama


A common place for the bars to crack, is at the ends where the shorting ring is attached.

It is not always obvious that there is a crack as the crack is often buried in the weld.


Best regards,


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...