marke Posted November 3, 2013 Report Share Posted November 3, 2013 Transfering data between two or more Horner OCS units is easy. Connect the two horners together via a cable using terminals 2 3 and 4 only on the CsCan Port. Connect 120 ohm resistors (Come with each Horner) between terminals 2 and 4 at each horner. Set the two IDs to be different, ie 253 and 252. You need to set the “target ID” in the software for the unit set to 252, to equal the ID ie 252. Example software attached for an XLe talking to an XL4.XL4 252 CanNetwork.cspXLE 253 CanNetwork.csp Mark Empson | administratorSkype Contact = markempson | phone +64 274 363 067LMPForum | Power Factor | L M Photonics Ltd | Empson family | Advanced Motor Control Ltd | Pressure Transducers | Smart Relay | GSM Control | Mark Empson Website | AuCom | Soft Starters Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now